This unit is used to link between production machines or board handling units.

The inspection conveyor is used when frequent visual inspection of PCB's is required in the PCB assembly line.

This unit is used to link between production machines or board handling units.

The unit installed after AOI for separated NG board for visual inspect and good board will pass through without stopping.

The unit installed after AOI for separated NG board for visual inspect and good board will pass through without stopping.

The unit provides a 'normal open' passage in a PCB assembly line. An integrated conveyor segment slides across the opening to deliver PCB to downstream machine.

This unit is used as a visual inspection station for operators controlling the boards right after a conformal coating line.

By manual lifting the conveyor section, access is gained to the rear of the line.

The unit loads your production line automatically by pushing PCB’s out of a magazine onto the conveyor of the downstream machine.

The unit loads your production line automatically by pushing PCB's out of the magazine onto the conveyor of the downstream machines. Full magazines are inserted at an ergonomic low level.

The unit loads your production line automatically by pushing PCB's out of the magazine onto the conveyor of the downstream machines. Full magazines are inserted at an ergonomic low level.

A large stack of unpopulated PCB's is placed above the ESD beltconveyor. Unique separation cams take one PCB from the bottom of the stack and lowers it onto the ESD belt conveyor.